Led block-Examples
1.Plot:
This program turns on the bottom right LED.
This program uses aĀ for loop and the plot function to make a square around the edges of the LED screen.
2.Toggle:
This code toggles the center LED
3.Unplot:
This program shows a picture on the LED screen, and then turns off the center LED with Unplot.
4.Point:
This program turns the center LED (2, 2) off if it is already on. (If it is already off, this program leaves it off.)
5.plot Bar Graph:
chart acceleration
Show a bar graph of theĀ accelerationĀ in theĀ x direction of the micro:bit. The micro:bitsĀ xĀ direction is from left to right (or right to left). The faster you move the micro:bit in this direction, the taller the lines in the bar graph will be. TheĀ high parameter isĀ 1023Ā which sets the highest possible value of acceleration to show.
6.Plot Brightness:
This program turns on the bottom right LED at 50% brightness.
This program uses aĀ for loop and the plot brightness function to make a square around the edges of the LED screen.
7.Toggle off
This program turns theĀ LED (1, 1) off it is not bright enough. (If it is already off, this program leaves it off.)
8.Brightness:
This program makes the screen completely bright when it is turned on (if it is not that way already)
9.Set Brightness:
This program makes the screen brightness 100% (255). Then it turns on the center LED (2, 2), waits for one second, and then sets the screen brightness to 50% (128)
10.Enable:
This program turns off the screen when pressing buttonĀ B
11.Stop Animation:
This program sets up the stop animation part of the program, and then shows a string that you can stop with button B.
12.set Display Mode:
Set the display mode to black and white.
